Six-String White LED Driver with Active
Current Balancing for LCD Panel Applications
In digital dimming mode, the step-up controller and
current source are directly turned on and off by the
PWM signal. The current pulse magnitude, or full-scale
current, is set by ISET and is independent of PWM duty
factor. The current-source outputs are PWM signals
synchronized to the BRT input signal (see Figure 5).
The full-scale current in both methods is specified by
resistance from the ISET pin to ground:
reduce flicker noise in the display. The current through
each FB_ pin is controlled only during the step-up con-
verter’s on-time. During the converter’s off-time, the cur-
rent sources are turned off. The output voltage does not
discharge and stays high. Each FB_ pin can withstand
28V, which is the pin’s maximum rated voltage.
Table 2 summarizes the characteristics of both analog
and digital dimming methods.
I LED max =
20mA × 100k Ω
R ISET
A PLL translates the duty cycle of the BRT input into a
reference for the MAX8790’s current sources. A resistor
from the FSET pin to ground controls the PLL’s free-
The acceptable resistance range is 80k Ω < R ISET <
running frequency:
133k Ω , which corresponds to full-scale LED current of
25mA > I LEDmax > 15mA. Connect ISET to V CC for a
default full-scale LED current of 20mA. When ENA is
f PLL =
1
10 × R FSET × 800 pF
high, the analog dimming is enabled, when ENA is low,
digital dimming is enabled.
When the current-source output is pulse-width modulated,
current-source turn-on is synchronized with the BRT sig-
nal. Synchronization and low jitter in the PWM signals help
The PLL’s loop filter bandwidth is set with a capacitor
from the CPLL pin to ground. This filter integrates the
phase difference between the BRT input signal and the
PLL oscillator. The filter bandwidth determines the
PLL’s dynamic response to frequency changes in the
BRT signal. For most applications, a 0.1μF capacitor is
D=
t ON
t BRT
DPWM DIMMING MODE
BRT
D = 50%
t ON
D = 30%
D = 12.5%
D = 6.25%
t BRT
I LEDMAX
I LED
0A
Figure 5. LED Current Control Using DPWM Dimming Mode
Table 2. Dimming Mode
MODE
ENA
PLL FREQUENCY
CPLL
DESCRIPTION
Analog dimming from 100% to 12.5% brightness. From
Analog + DPWM
> 2.1V
250k Ω < R FSET < 754k Ω
0.1μF
12.5% to 1% brightness, DPWM dimming is employed.
BRT frequency range is 100Hz to 500Hz.
Direct dimming by BRT signal. BRT frequency can be
Direct DPWM
< 0.8V
V FSET > V CC - 0.4V, disables PLL
OPEN
100Hz to 2kHz; 50μs minimum BRT on-time limits the
minimum brightness.
______________________________________________________________________________________
15
相关PDF资料
MAX8791GTA+ IC MOSFET DRIVER 8-TQFN
MAX8811EEE+ IC DRVR DL PHASE HS 16-QSOP
MAX8821ETI+ IC LED DRVR WHITE BCKLGT 28-TQFN
MAX8822ETE+T IC LED DRVR WHITE BCKLGT 16-TQFN
MAX8830EWE+T IC LED DRVR WHITE BCKLGT 16-UCSP
MAX8831EWE+T IC LED DRIVR WHITE BCKLGT 16-WLP
MAX8834ZEWP+T IC LED DRIVR BCKLGT FLASH 20-WLP
MAX8855EVKIT+ KIT EVAL FOR MAX8855
相关代理商/技术参数
MAX8790EVKIT+ 功能描述:LED 照明开发工具 RoHS:否 制造商:Fairchild Semiconductor 产品:Evaluation Kits 用于:FL7732 核心: 电源电压:120V 系列: 封装:
MAX8791AGTA+ 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述:
MAX8791AGTA+T 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述:
MAX8791BGTA+ 功能描述:功率驱动器IC Single-Phase Synch MOSFET Driver RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
MAX8791BGTA+T 功能描述:功率驱动器IC Single-Phase Synch MOSFET Driver RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
MAX8791GTA+ 功能描述:功率驱动器IC Single-Phase Synch MOSFET Driver RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
MAX8791GTA+T 功能描述:功率驱动器IC Single-Phase Synch MOSFET Driver RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
MAX8792ETD+ 制造商:Maxim Integrated Products 功能描述:SOFT SW PWM CNTRLR 1-OUT PWM CNTRLR 600KHZ 14TDFN EP - Rail/Tube 制造商:Maxim Integrated Products 功能描述:SINGLE QUICK- PWM STEP DOWN CONTROL